Schoeps CMC 6 U Stereo Set | Microphone Configurator
2.989€ – 3.599€
- Stereo set with 2x CMC 6 U each + capsule + clamp + pop shield + case
- constant frequency response
- completely balanced signal routing, especially low impedance output
- safe against RF interference with “RFI Shield
The CMC 6 is Schoep’s most popular microphone amplifier. Its signal routing is completely symmetrical. The electrical characteristics of the CMC 6 set standards in terms of its low distortion and unbalance attenuation.
Microphone capsules of condenser microphones cannot be operated directly on microphone cables or inputs. This requires the interconnection of a microphone amplifier. Each MK capsule of the Colette series must therefore be screwed to a microphone amplifier and only together with it forms a complete microphone.
The CMC 6 U can be operated on 12V and 48V phantom power. The circuitry of the CMC 6 U automatically detects the supply and adjusts to it. Their properties remain essentially unchanged – only the current is adapted to the supply voltage. This is higher at 12V than at 48V. Nevertheless, the power consumption is lower at 12V, which is advantageous for battery operation.
Scope of delivery: 2x CMC 6 U each, MK xx capsule (with pairing certificate), SG 20 clamp, B 5 D (for spherical capsules) or B 5 (for all other capsules) pop shield, Velcro cable tie, Premium Case
- Frequency range: 20 Hz – 20 kHz
- Sensitivity: see corresponding capsule
- Max. Output voltage:1 V (0 dBV) at 1 kΩ load
- Grenzschalldruck (THD <, encoded_tag_open0,5%): mit MK 4: 131 dB-SPL
(P-48V, P-12V) - Low Cut: 20 Hz, 12 dB/oct.
- Smallest recommended load impedance: 1 kΩ
- Output impedance: 42 Ω
- Maximum cable length: > 400 m
- Current consumption: 4 mA (P-48V); 8 mA (P-12V)
- Common mode rejection outputs (CMRR) (at 1kHz): > 55 dB
- Output: XLR-3M
- Length: 116mm
- Diameter: 20mm
- Weight: 60g
- Surface: matte gray; special colors: Nickel, chrome green and
more on request
CMC Microphone amplifier
In addition to the standard version of the CMC 6 U, the following variants are available on request for an additional charge:
CMC 6 linear (No. 193002)
The CMC 6 microphone amplifier has a lower cutoff frequency of 20 Hz to keep infrasonic noise of various origins, e.g. due to air currents or vibrations, low. However, when using pressure receivers, there may be a desire to record frequencies below 20 Hz without attenuation. The CMC 6 linear allows this. On request, it can be supplied with a lower cut-off frequency of 10 Hz. Caution: Since pressure receivers also pick up infrasound down to very low frequencies, even noise from ventilation systems or rail vehicles can become problematic in large rooms, e.g. churches. The danger is even greater with pressure gradient receivers. Although they transmit the lowest frequencies from the sound field only weakly, they react all the more violently to other, undesirable stimuli such as air movements and structure-borne sound. Although these signals are outside the audible range, they can cause strong, audible distortion due to overdriving, especially of inputs with undersized transformers.
CMC 6 U +5 dB (No. 193001)
Microphones with such marked amplifier are 5dB more sensitive than the standard version. The limiting sound pressure level is reduced by 5dB and the disturbance-free voltage range decreases slightly. Using this version can still be advantageous if you need to boost the microphone signal above the noise level of the connected device, or if you usually record rather low levels. Otherwise, it is more likely to overload the input of the connected device or the microphone amplifier itself at high sound pressure levels.
Color | Grey |
---|---|
Kapsel | MK 2 (Omni), MK 21 (Wide cardioid), MK 22 (Open cardioid), MK 2H (Omni with mild high-frequency elevation), MK 2S (Omni with moderate high-frequency elevation), MK 2XS (Omni with diffuse-field equalized), MK 4 (Cardioid), MK 41 (Supercardioid), MK 41V (Supercardioid for side-addressed pickup), MK 4V (Cardioid with mild high-frequency elevation for side-addressed pickup), MK 5 (Omni + Cardioid), MK 8 (Figure 8) |
Tube | No |
Mic Converter | Condenser microphone (FET) |
+48 Volt phantom power | Yes |
Only logged in customers who have purchased this product may leave a review.
Q & A
Ask a question
Your question will be answered by a store representative or other customers.
Thank you for the question!
Your question has been received and will be answered soon. Please do not submit the same question again.
Error
An error occurred when saving your question. Please report it to the website administrator. Additional information:
Add an answer
Thank you for the answer!
Your answer has been received and will be published soon. Please do not submit the same answer again.
Error
An error occurred when saving your answer. Please report it to the website administrator. Additional information:
Related Products
- FET condenser microphone, large diaphragm
- Polar pattern: cardioid
- 35Hz – 20kHz (+/-3.5dB)
- -10dB pad switch, 80Hz low cut switch
- Kick Drum Microphone
- Dynamic microphone
- Polar pattern: cardioid
- 20Hz – 15kHz
- Large diaphragm condenser microphone
- Cardioid
- -15dB pad
- for bass drums
- Small diaphragm condenser microphone
- Cardioid
- -10dB pad
- for snare drums
Reviews
There are no reviews yet