Schoeps CMC 1 L | Microphone Amplifier
869€
Brand: Schoeps
Shipping in 1-2 working days
- Variant of the CMC 1 U with Lemo miniature connector
- constant frequency response
- very low distortion
- for operation with 12 V or 48 V phantom powering
- completely balanced signal routing, especially low impedance output
- safe against RF interference with “RFI Shield
Schoeps’ CMC 1 L is a microphone amplifier that is approximately 66% smaller and 53% lighter than the CMC 6. It can be used with all components of the Colette system, including the MK capsules, without any compromise instead of a CMC 6. Thus, it offers uncompromising miniaturization for applications where microphone size is an issue.
The electrical and sonic characteristics of the CMC 1 are in no way inferior to the CMC 6. On the contrary: through elaborate, modern electronic design, it has been possible to achieve outstanding electrical properties. Thus, it is particularly high output (135 dB-SPL with the MK 4) and still consumes very little current (2 mA at P48).
No. 191102 Special colors: Nickel, chromagreen, other special colors on request
No. 191201 special engraving
Scope of delivery: CMC 1 L, SG 20 clamp
- Frequency range: 20 Hz – 20 kHz
- Sensitivity: see corresponding capsule
- Max. Output voltage: 1.8 V (5 dbV) at 1 kΩ load
- Limiting sound pressure level (THD <0.5%):
- 135 dB-SPL (P-48V) with MK 4; 131 dB-SPL (P-12V) with MK 4.
- Low Cut: 20 Hz, 12 dB/oct.
- Lowest recommended load impedance: 1 kΩ
- Output impedance: 50 Ω +/- 1 Ω (8 Hz – 50 kHz)
- Maximum cable length: > 400 m
- Current consumption: 2 mA (P-48V); 3 mA (P-12V)
- Common mode rejection outputs (CMRR) (at 1kHz): > 55 dB
- Output: XLR-3M
- length: 25.5mm
- Diameter: 20mm
- weight: 28g
- Surface finish: matte gray; special colors: nickel, chromagreen and others on request
CMC Microphone amplifier
Microphone capsules of condenser microphones cannot be operated directly on microphone cables or inputs. This requires the interconnection of a microphone amplifier. Each MK capsule of the Colette series must therefore be screwed to a microphone amplifier and only together with it forms a complete microphone.
The CMC 1 L can be operated on 12V and 48V phantom power. The circuitry of the CMC 1 L automatically detects the supply and adjusts to it. Its characteristics remain essentially unchanged – only the current is adapted to the supply voltage. This is higher at 12V than at 48V. Nevertheless, the power consumption is lower at 12V, which is advantageous for battery operation.
The CMC 1 is available in three variants:
CMC 1 U: Output connector XLR3M
CMC 1 L: Output connector Lemo
CMC 1 K: fixed 5m XLR cable
Color | Grey |
---|---|
Tube | No |
Mic Converter | Condenser microphone (FET) |
+48 Volt phantom power | Yes |
Only logged in customers who have purchased this product may leave a review.
Q & A
There are no questions yet
Ask a question
Your question will be answered by a store representative or other customers.
Thank you for the question!
Your question has been received and will be answered soon. Please do not submit the same question again.
Error
An error occurred when saving your question. Please report it to the website administrator. Additional information:
Add an answer
Thank you for the answer!
Your answer has been received and will be published soon. Please do not submit the same answer again.
Error
An error occurred when saving your answer. Please report it to the website administrator. Additional information:
Related Products
Sontronics DM-1S | Snare Drum Microphone
Rated 0 out of 5
159€
- Small diaphragm condenser microphone
- Cardioid
- -10dB pad
- for snare drums
Avantone CK40 – Stereo Multi-Pattern FET Microphone
Rated 0 out of 5
689€
- Stereo FET condenser microphone, large diaphragm
- Polar pattern: cardioid, omnidirectional, figure-of-eight (x2)
- 20Hz – 20kHz (+/-3dB)
- -10dB pad switch, 80Hz low cut switch
Avantone CV-12 BLA
Rated 0 out of 5
609€
- Tube microphone with BLA circuitry
- 9 Polar Patterns available (Circle, Cardioid, Eight)
- 20Hz – 20kHz (+/-3dB)
- -10dB pad switch, 80Hz low cut switch
Avantone CK-1 – Small-Capsule FET Pencil Mic
Rated 0 out of 5
179€
- FET condenser microphone
- Polar pattern: omnidirectional, cardioid, hypercardioid
- 25Hz – 20kHz (+/-3dB)
- -10dB pad switch, 80Hz low cut switch
Reviews
There are no reviews yet