Schoeps CMC 1 KV Lemo for Sound Devices | Set with magnet mounting
1.699€ – 1.999€
- Version of the CMC 1 with capsule and fixed, laterally extending cable
- Magnetic mounting (accessories included)
- Constant frequency response + very low distortion
- completely balanced signal routing, especially low impedance output
- safe against RF interference with “RFI Shield
The CMC 1 KV from Schoeps is a microphone amplifier that is approximately 60% smaller and 40% lighter than the CMC 6. It is identical to the CMC 1 U, but has an attached cable instead of a built-in XLR connector. It can be used without any compromise instead of a CMC 6 with all components of the Colette system, including the MK capsules. It therefore offers uncompromising miniaturisation for applications in which the size of the microphone plays a role.
The electrical and tonal characteristics of the CMC 1 are in no way inferior to the CMC 6. On the contrary: thanks to sophisticated, modern electronic design, outstanding electrical properties have been achieved. This means that it can be driven at a particularly high level (135 dB-SPL with the MK 4) and still consumes very little power (2 mA at P48).
The CMC 1 KV is available in the following variants:
-
- #132018: 2 m cable with XLR-3M connector
- #132019: 0.5 m cable with Lemo 3pin for Sound Devices
- #132020: 0.5 m cable with Lemo 3pin for Zaxcom
- Special version with any cable length
No. 191102 Special colours: Nickel, chrome green, other special colours on request
No. 191201 Special engraving
- Frequency range: 20 Hz – 20 kHz
- Sensitivity: see corresponding capsule
- Max. Output voltage: 1.8 V (5 dbV) at 1 kΩ load
- Limit sound pressure level (THD <0,5%):
135 dB-SPL (P-48V) with MK 4; 131 dB-SPL (P-12V) with MK 4 - Low Cut: 20 Hz, 12 dB/oct.
- Smallest recommended load impedance: 1 kΩ
- Output impedance: 50 Ω +/- 1 Ω (8 Hz – 50 kHz)
- Maximum cable length: > 400 m
- Power consumption: 2 mA (P-48V); 3 mA (P-12V)
- Common mode rejection outputs (CMRR) (at 1kHz): > 55 dB
- Output: XLR-3M, Lemo Sound Devices or Lemo Zaxom
- Length: 25,5mm
- Diameter: 20mm
- Weight: 28g
- Surface: matte gray; special colors: Nickel, chrome green and
more on request
Scope of delivery: CMC 1 KV, capsule, SGC clamp, magnetic angle piece 30°, magnetic angle piece 45°, disc magnet 20 mm, self-adhesive magnetic pad 5 cm black, suction cup with magnet
CMC Microphone amplifier
Microphone capsules of condenser microphones cannot be operated directly on microphone cables or inputs. This requires the interconnection of a microphone amplifier. Each MK capsule of the Colette series must therefore be screwed to a microphone amplifier and only together with it forms a complete microphone.
The CMC 1 KV can be operated with 12V and 48V phantom power. The CMC 1 KV circuit automatically recognises the power supply and adjusts itself accordingly. Their properties remain essentially unchanged – only the current is adapted to the supply voltage. This is higher at 12V than at 48V. Nevertheless, the power consumption is lower at 12V, which is an advantage in battery operation
Color | Grey |
---|---|
Port | XLR |
Kapsel | MK 4 (Cardioid), MK 41 (Supercardioid), MK 41V (Supercardioid for side-addressed pickup), MK 4V (Cardioid with mild high-frequency elevation for side-addressed pickup), MK 5 (Omni + Cardioid), MK 8 (Figure 8) |
Tube | No |
Mic Converter | Condenser microphone (FET) |
+48 Volt phantom power | Yes |
Only logged in customers who have purchased this product may leave a review.
Q & A
Ask a question
Your question will be answered by a store representative or other customers.
Thank you for the question!
Your question has been received and will be answered soon. Please do not submit the same question again.
Error
An error occurred when saving your question. Please report it to the website administrator. Additional information:
Add an answer
Thank you for the answer!
Your answer has been received and will be published soon. Please do not submit the same answer again.
Error
An error occurred when saving your answer. Please report it to the website administrator. Additional information:
Related Products
- FET condenser microphone
- Heiserman HZ capsule
- Cinemag transformer
- NOS FETs
- Small diaphragm condenser microphone
- Cardioid
- -10dB pad
- for snare drums
- Pro-Klamp microphone holder for drums
- three-stage rubber damping
- for mounts with 5/8″ thread
- Kick Drum Microphone
- Dynamic microphone
- Polar pattern: cardioid
- 20Hz – 15kHz
- Specialized in speech and vocals
- Neumann U-47 Character
- developed with the collaboration of Abbey Road Studios
Reviews
There are no reviews yet