SPL Audio DMC
5.190€
Color: Black: Lieferung in 1-2 Werktagen
Color: Red: Lieferung in 5 Werktagen
Color: SPL All Black: Lieferung in 1-2 Werktagen
Mastering Console
8 stereo inputs
max. 4 stereo speakers, 1 mono speaker, 1 subwoofer
120V technology
The DMC Mastering Monitor Controller is the heart of SPL Audio’s mastering series. This is where feeds and speakers are connected. Therefore, the quality is of crucial importance. Like all other devices in the series, the DMC uses SPL’s proprietary 120V technology.
- Maximum input and output level: 32.5dBu
- Input impedance: 20kΩ
- Output impedance: 75Ω
- Common mode rejection (0dBu, 1kHz: -82dBu
- Frequency response (-3dB): 4Hz – 300kHz
- THD + N (+24dBu, Rec Out, Insert On): >112dB
- THD + N (+24dBu, Speaker Out): >108dB
- Noise (A-weighted, Rec Out, Insert On): -101.6dBu
- Noise (A-weighted, Speaker Out): -106.9dBu
Mastering Console
On the front panel are all parameters and settings for the inputs on the left side, and for the outputs on the right side.
There are 8 stereo inputs in total, which are XLR sockets. Four of them are used for sources (Sources), which are intended for comparing audio material. The other four stereo inputs are used for audio that is to be processed. Each input can be switched on and off, phase rotated and levelled in 0.25 dB steps. In addition, it is possible to monitor each of the 8 inputs in mono. The large “Recording Gain” pot can be used to sensitively change the volume of the signal. If it is not used, it should be deactivated via the corresponding button to remove it from the signal path.
Three speaker pairs, a mono speaker and a subwoofer can be connected to the DMC. Via the Phonitor HP Out, the signal is passed on to a headphone amplifier. Optionally, it can be programmed that speakers are automatically switched off in headphone mode. It can also be programmed that the subwoofer is only activated with certain monitor pairs. To compensate for a level difference after the insert chain, the insert return can be corrected in 0.25 dB steps.
Via the monitoring section, each speaker channel can be monitored solo and phase rotated. Volume compensation in the range of +/-10 dB can also be performed. Alternatively, it can be linked to the Insert, Sources or Input switches. Further buttons allow muting or mono switching.
Weight | 12,35 kg |
---|---|
Dimensions | 55 × 46 × 20 cm |
Color | Black, Red, SPL All Black |
Channels | Mono, Stereo |
Port | XLR |
Format | 19inch |
Einheiten (HE) | 3 |
Only logged in customers who have purchased this product may leave a review.
Q & A
Ask a question
Your question will be answered by a store representative or other customers.
Thank you for the question!
Your question has been received and will be answered soon. Please do not submit the same question again.
Error
An error occurred when saving your question. Please report it to the website administrator. Additional information:
Add an answer
Thank you for the answer!
Your answer has been received and will be published soon. Please do not submit the same answer again.
Error
An error occurred when saving your answer. Please report it to the website administrator. Additional information:
Related Products
- Mastering Insert Router
- max. 8 effect units
- 2 parallel mix stages
- 120V technology
- Transient Designer
- with differential envelope technology
- in 500 format
Available on backorder
- Mastering M/S Processor
- Balance and Trim for Mid signal
- Elliptical filter and stereo width for side signal
- 120V technology
- Microphone preamplifier
- Gain: 26 dB – 59 dB (up to 76 dB via jumper)
- Impedance control: 150 Ohm to 22 kOhm
- 3-band EQ
Available in our demo studio Dresden. Arrange appointment
- Mono Class-A and tube preamplifier
- +48V phantom power
- XLR and TS input + AD input 2
- S/PDIF input and output
Reviews
There are no reviews yet